Timber Sleepers

HERMEQ timber sleepers cover two kinds of work: landscaping in gardens and grounds, and ground-level boundaries on construction sites. Baulk timbers, also known on site as wooden sleepers, are heavy square sections in two lengths. They are laid alongside roadways and around scaffold to mark a clear edge between traffic, pedestrians and temporary works. Green oak sleepers are untreated hardwood for raised beds, borders, retaining walls and steps on domestic and commercial schemes. Both are manufactured in the UK and can be bought online with nationwide delivery.

2 Items

Set Descending Direction
per page

Garden sleepers and site baulk timbers

Within the timber products range, sleepers divide by the job they are bought for: green oak for landscaping that is built once and stays in place, and baulk timbers for marking out working areas on construction sites.

Green oak sleepers

Green oak sleepers are the choice when the sleeper becomes part of a finished landscape. The oak is a hardwood supplied untreated. It can be cut to length, stacked in courses and screwed together into raised beds, borders, steps and low retaining walls. Landscaping contractors, facilities teams looking after grounds and garden designers use it where the timber will be seen at close quarters for years.

Baulk timbers

Baulk timbers are heavy square-section timbers laid on the ground to form a boundary around scaffold, roadside works and site layouts. On site they are also called wooden sleepers or safety timbers. Choose them when the task is to mark a solid, clearly visible edge around a working area on a construction, groundworks or highway contract.

Green oak sleepers stacked beside red and white baulk timbers
Baulk Timber - Wooden Sleepers

Uses for timber sleepers

Raised beds and vegetable beds

A raised bed lasts longest when its bottom course sits on a firm, level and free-draining base, such as compacted gravel, so the timber never stands in wet soil. A permeable membrane lining the inside faces keeps damp soil off the oak and still lets water through, whereas a sealed plastic liner traps water against the timber. Green oak is supplied untreated, so no preservative is in contact with the soil, and that is why it is the usual choice for vegetable, fruit and herb beds.

Edging, borders and steps

Edging and borders need little more than a single course bedded into the soil or a gravel strip, laid to the line and level of the lawn or path it holds. Steps are more demanding: each tread is bedded level on compacted ground, each riser is fixed back into the bank, and an anti-slip strip on the tread is worth fitting where the steps take daily foot traffic. Where a border runs along a boundary that also needs screening, garden fencing can stand behind the sleepers. For a low edge along a path or drive, timber posts and rails form a post-and-rail line.

Retaining walls and terracing

The height of the build decides the method. Low terraces of a few courses, with staggered joints and each course fixed to the one below, sit within an ordinary landscaping job. Walls that hold back more soil need restraint designed for the load, such as posts set deep into the ground behind the face, and a drainage path behind the timber, usually gravel backfill with an outlet at the base, so that water does not build up behind the wall. Higher walls, and walls beside paths or buildings, are a design matter for an engineer.

Scaffold perimeters and roadside works

On site, baulk timbers are laid end to end on the ground to form a visible boundary around scaffold bases, roadside works and the layout of compounds, walkways and storage areas. Before ordering, decide who has to see the line. Where pedestrians walk past and plant operators manoeuvre close by, the contrasting finish of the baulk timber is the reason to choose it over plain timber or a sprayed line. Where live traffic needs separating from the works or from pedestrians, road barriers are the product for that run, with baulk timbers marking the ground-level edge.

Sleeper sizes, handling and fixing

Length and section

Lengths across the range run from 2.4m for green oak to 6m for the longest baulk timbers. Choose the length that suits the run. A full length laid in one piece means fewer joints and less cutting, which in a raised bed or edge also means fewer places where courses can open up, and on site a longer baulk timber marks out a long boundary with fewer gaps. For oak builds, set out the bed or wall to whole or half sleeper lengths where the design allows, and allow for the thickness of the sleeper at each corner where courses overlap.

Handling and placement

Green oak sleepers are laid by hand, normally as a two-person lift, so the oak can go into back gardens and tight landscaped areas that machines cannot reach. Baulk timbers are placed with lifting equipment, such as a telehandler or an excavator with suitable lifting accessories. The plan for a site job therefore covers access for the delivery vehicle, a lifting position near the boundary and a set-out line marked before the timbers arrive. Moving a baulk timber later means bringing the machine back, so the layout is best fixed first.

Fixing and laying

Green oak sleepers are built with timber lock screws driven through one sleeper into the next, pre-drilled close to the ends. Stagger the joints between courses as in brickwork, so that no vertical joint runs through the full height, and fix every course to the one below and across each corner. Green oak moves as it dries, which is normal behaviour for the material, so leave a small gap where a sleeper meets paving or a wall, and check and tighten the screws after the first dry season. Baulk timbers are laid loose on firm, level ground, with the ends butted together to close the line.

Green Oak Sleepers

Frequently Asked Questions

What are timber sleepers?

Timber sleepers are heavy sections of sawn timber that are laid on the ground or stacked into a structure. The name comes from the railway, where sleepers were laid across the track bed to carry the rails, which is why landscaping sleepers are still called railway sleepers. Today the same kind of section is made new for gardens and landscaping, and in larger square sections for marking boundaries on construction sites.

How long do oak sleepers last?

Green oak is a hardwood, and the HERMEQ green oak sleeper is expected to last up to 30 years outdoors. The way it is laid affects that life. Sleepers on a free-draining base, with air around them and no standing water against the timber, last longer than sleepers buried in wet soil.

Do green oak sleepers need treating?

No. Oak has its own natural durability, so the sleepers are supplied untreated and can be used outdoors without a preservative. Cut ends can be sealed with an end-grain sealer or a clear oil to slow drying at the cut and reduce splitting from the end. An oil on the faces holds the fresh colour for longer if that look is wanted.

Are new sleepers the same as reclaimed railway sleepers?

No. Reclaimed railway sleepers come out of old track and often carry fixing holes, worn faces, uneven sizes and an unknown treatment history, which in older sleepers can include creosote. HERMEQ sleepers are new timber cut to a consistent section, so the condition and finish of every sleeper is known before it is laid.

Why does green oak split as it dries?

Green oak is sawn and supplied before it has been seasoned, so it still holds much of its natural moisture. The outer faces dry faster than the core, fine splits called checks open along the grain, and the section shrinks slightly; this is normal in oak of this size and is not a defect. In the first months, tannins washed out by rain can mark paving below the timber, and the surface weathers to silver grey unless it is oiled.

Why are baulk timbers painted red and white?

The red and white wax-painted finish makes the timber easy to pick out at ground level, where bare timber blends into mud, hardcore and stored materials. Red and white is the contrast used for temporary hazard marking on construction sites, so pedestrians and plant operators recognise the line as a boundary at a glance.